GE FANUC TGT-S00N-1-1-CA Whedco System Module System Module in stock
TGT-S00N-1-1-CA then the timer K value can be 510 (T1 is 100ms timer). When X001=1, the operation of the controlled object starts and T1 starts timing; if the operation procedure of the controlled object can be finished normally within the specified time, X002 will act, M1 will be reset and timer T1 will be cleared to wait for the start of the next cycle; if the action signal of the completion of the operation of the controlled object is not issued in the specified time, it will be judged as a fault and the contact of T1 will be closed and M2 will be connected to issue an alarm signal or stop signal.
| TGT-S00N-1-1-CA |
| RS-FS-9001 |
| IC697CPM790-GD |
| IS220PSCAH1A |
| DS200PCCAG1ABB |
| IS200TTURH1CFD |
| IS220PPROH1A |
| DS200TCEBG1ACE |
| IS200TSVCH1AJE |
| HE700GEN200 |
| IS215VCMIH2C |
| DS303 A7A01LXA002XN |
| IC698CPE030-GJ |
| 369-HI-R-M-0-0-0-E |
| IS200TRLYH1BGF |
| IS420UCSBH1A |
This article is from the official website of Xiamen Xiongba, please include the following link for reproduction：www.plcdcsmodule.com | GE FANUC TGT-S00N-1-1-CA Whedco System Module System Module in stock
3005319639